juozas rašė:
Sveiki, mano Lagunai problema tokia pati. Kadangi aukščiau neradau problemos sprendimo būdo, siųlau padiskutuoti. Bet pradžioje apie viską iš eilės: Laguna II, 2003 m, daužtas kairys kampas. Sugadintas ABS/ESP blokas, nukirsti laidai. Raidžių ir skaičių neliko todėl nupirkau kitą iš automobilio su ESP. Sulitavau laidus. Užpildžiau sistemą. ABS veikia. ESP ne. Nuskanavau klaidas DF107 steering wheel angle sensor identifier. Skanavimas kaip visada nepadėjo.
Klausimas: Kaip yra su vairo padėties davikliu ar jį reikia pririšti ar sukalibruoti ar dar kažkaip identifikuoti? Autodatoje parodyta, kad iš steering position sensor su ABS bloku sujungti 25 ir 29 kontaktais jų laidai tvarkingi. Nebežinau kaip remontuoti. Ačiū visiems už pagalbą.
DF107
PRESENTSTEERING WHEEL ANGLE SENSOR IDENTIFIER
NOTES Special notes: None.
Program the steering wheel angle using the diagnostic tool by selecting the configuration VP003 Steering
wheel angle sensor.
If attempts to program fail, replace the steering wheel angle sensor.
siaip pakeitus ABS/ESP bloka reiktu dar ir kitus parametrus paziureti/jei reikia pakeisti
REPLACING THE COMPUTER:
After replacing a computer, configure as follows:
– Programming the "tachometric index".
The TEVES MK60 ABS/ESP computer with the tachometry function transmits the vehicle speed signal to all
areas where this signal is needed (instrument panel, engine management, etc.).
This vehicle speed signal replaces the one supplied by the speed sensor located on the gearbox.
The ABS/ESP computer calculates the vehicle speed from the wheel speed and the tyre circumference.
The tyre circumference must be programmed into the memory of a new computer. This consists of
entering an index "X", using the VP007 "Tachometric Index " control on the diagnostic tool.
Once the index has been entered using the VP007 command, clear the computer memory and then switch off
the ignition. Use the PR030 parameter to check that the index has been stored correctly.– ABS/ESP calibration:
Select command CF077 on the diagnostic tool.
– Adaptive cruise control:
Select command CF078 on the diagnostic tool.
– Gearbox type:
Select command CF079 on the diagnostic tool.
– Vehicle parameters (drive torque index configuration + brake type):
Select command CF080 on the diagnostic tool.
– To program the steering wheel angle:
Select command VP003 on the diagnostic tool.